Click on Audio tab you need to set the DX10 USB Audio Codec for each Input and Output from the dropdown menu, plus you need Mono on both inputs showing. Data-U is cleaner signal than USB for Mode, audio signal is spread out more in USB.

you will transmit on a lower or higher frequency than when receiving especially when the incoming signal is strong and clustered with many call signs.

Now install WSJT-X v2.3.1 open File>Settings for General you need your Call Sign, Grid location and IARU Region.RadioTab> Rig as OmniRig 1, set Baud rate same as for Omnirig, 8, 2, None PTT Method> CAT Mode> Data/Pkt on the DX10 radio you should select DATA-U for VFO-A and VFO-B as when you select Split Operation> Rig. Now Install Omnirig v1.9 select Rig type - FTDX10, Port - Enhanced Port number and set the Baud rate to what you want, has to be the same on radio. To confirm go to the Control Panel>Device Manager and check Ports (COM & LPT)d two extra ports have been established, one Enhanced and one Standard. Ok guys this is my take on how i run FT8 FT4 with WSJT-X, JTAlert, Log4om 2 and Gridtracker all together using omnirig v1.9 (latest does not work with all these programs) On DX 10 if you have the latest firmware you will notice Preset, Click or touch screen VFO-A select Data-U and in that box notice bottom right corner Preset, click or touch to enable, if you hold down Preset longer another window opens showing settings, i have only 3 settings changed from Default, HCUT FREQ - 3000, RPort Gain - 20 and RPTT Select - DAKY For the DX10 raido Radio Setting > Mode SSB i have two settings changed from Default: TX BPF SEL - 50 - 3050 Hz, SSB MOD SOURCE - Rear and in Mode PSK/Data - i have 3 settings changed from Default: TX BPF SEL - 50 - 3050 Hz, REAR SELECT - USB and RPORT Gain - 20 (for info when setting your ALC meter, you want the needle to not go above 1 on the meter when you look at the radio to confirm if ALC is too high go into RPORT Gain and reduce, you can also do this for the Preset) Have you installed the Yaesu USB drivers from website, do not install USB cable to radio to computer until you have downloaded the USB virtual drivers and installed them.

Easypal setup windows 7